whisker Litter-Robot 4 - Reset Button and Night Light Control; Empty Button and Cycle Delay Setting; Connect Button for WiFi

www.whiskersuppo.com
19
Press the Reset buon while the Globe is at the Home position with the blue Light Bar on to
reset the Cat Sensor(s). When pressed during a cycle, it will pause the cycle. If pressed again
while paused, it will abo the cycle. When pressed with the red Light Bar on, it will cancel the
Cat Sensor Cycle Delay and the unit will return to Ready Mode (blue Light Bar on).
A 3-second long press enables or disables Automatic Night Light Seing Mode (see page 23).
Press the Empty buon while the Globe is at the Home position with the blue Light Bar on to
sta an Empty cycle (see page 17). When pressed during a Clean cycle or Empty cycle, it will
pause the cycle. Pressing the Empty buon during a paused cycle will abo the cycle and
send the Globe back to the Home position.
A 3-second long press enables or disables Cycle Delay Seing Mode (see page 24).
Press the Connect buon to turn WiFi ON or OFF.
1. WiFi OFF is indicated by a white light adjacent to the Connect buon.
2. WiFi ON and connecting is indicated by a blinking blue light adjacent to the Connect
buon.
3. WiFi ON and connected is indicated by a solid blue light adjacent to the
Connect buon, completing the blue Light Bar.
A 3-second long press will initiate Onboarding Mode indicated by a blinking yellow light
adjacent to the Connect buon. Press and release to exit Onboarding Mode.
Reset + (Automatic Night Light)
Empty Buon + (Cycle Delay Seing)
Connect Buon