www.whiskersuppo.com
15
Ongoing Maintenance
Empty the Waste Drawer when indicated by the Light Bar flashing blue on the Control Panel.
How oen you will need to empty the Waste Drawer depends on the number and size of your
cats. For two average-sized cats, twice per week is typical. For a single cat, once per week is
usually sucient.
Pull out the Waste Drawer, gather the edges of the liner bag, and dispose.You can use
Lier-Robot custom-t Waste Drawer Liners or any 37-49L trash bags.
To install a new Waste Drawer Liner, open the bag and wrap the opening over the perimeter of
the Waste Drawer flange. Push the remainder of the bag into the boom of the Waste Drawer.
Slide the drawer back in, being careful not to push the unit against the wall or into a corner
(should not be touching any walls for accurate weight measurements). Then, press the Reset
buon to zero the Weight Sensors.
Add lier as needed.
Check the lier level once per week or each time you empty the Waste Drawer. Add just
enough lier to meet the raised MAX Fill Line inside the Globe, and be careful not to oveill
it to avoid wasting lier. Aer adding or removing lier, press the Reset buon to zero the
Weight Sensors.
Press the Reset buon.
Any time you aect the weight or placement of the unit (including emptying the Waste
Drawer, adding or removing lier, or cleaning or moving the unit), press the Reset bu on to
ensure the Weight Sensors will detect your cat and cycle properly.
See Use and Care on page 29 to learn about the Carbon Filter, Base Seal Strips, Waste Drawer
Liners, and how to clean the Lier-Robot.
Waste Drawer Liner Is
Inseed Here
Waste
Drawer
To Next Page
Loading...
Need help?
General
