whisker Litter-Robot 4 - Setting Up Your Litter-Robot; Placement Guidelines; Litter Selection and Filling

www.whiskersuppo.com
12
Seing Up Your Lier-Robot
Your Lier-Robot comes fully assembled and ready to use. Get staed by following
the steps below.
Placement
 If possible, place the Lier-Robot in the same location as the old lier box (at least
during transition).
 Make sure the unit is on a rm, level suace. Avoid so, uneven, or unstable flooring.
 Keep the unit indoors in a cool, dry location. Reduce exposure to high temperature
and humidity. If possible, keep out of direct sunlight.
 Place the unit near a power outlet. Ensure the unit isn't pushed against a wall or into a
corner (must not be touching any walls).
 Place lier mats or rugs in front of the unit. Do not place mats paially under the unit.
If the unit must be placed on carpeting, it is strongly recommended to use the Carpet
Tray accessory that is available for purchase on Lier-Robot.com..
DO NOT use liers that are the strictly absorbent, non-clumping, loose-clumping,
newspaper-based, or wood-based pellets.
Lier
Fill the Globe through the circular opening with
clumping lier until it meets the raised MAX Fill
Line when spread flat—approximately 3.6-4.5
kg by weight or 4L by volume. Be careful not to
oveill the Globe.
The Lier-Robot lier siing system requires
clumping lier to work properly. We recommend
a high-quality, clay-clumping lier. Lier beads
and crystals that are small enough to pass
through the screen will also work (periodic
changing of this type of lier is required).
Translucent or white-colored lier (most oen
seen in crystal lier) may impact the lier level
and Drawer Full Indicator (DFI) accuracy.
Litter
Fill line