www.whiskersuppo.com
20
Control Panel - Light Bar
Blue Light Bar Solid: Ready Mode.
Blue Light Bar Flashing: Waste Drawer is full (see page 22).
WiFi Light Status: (see page 26).
Blue: WiFi is connected.
White: WiFi is turned o.
Blinking Blue: WiFi is disconnected / reconnecting.
Blinking Yellow: Unit is in Onboarding Mode.
Yellow Light Bar Solid: Unit is paused during a cycle.
Yellow Light Bar Flashing: Bonnet is removed. The unit will resume its previous function
5 seconds aer the Bonnet is replaced (see page 27).
Yellow Round Robin Light Bar: Unit is peorming a Clean or Empty cycle (see page 16).
Yellow Ping Pong Light Bar: Cycle interrupted by the Anti-Pinch Safety Feature (see
page 28).
Red Light Bar Solid: Cat detected and Cycle Delay Countdown initiated.
Blue Light Bar with Paial Yellow Flashing - unit rmware of 2.87+: Excess weight detect-
ed for more than 30 minutes.
Red Light Bar Flashing - unit rmware of 2.86 and below: Excess weight detected or cur-
tain sensors activated for more than 30 minutes.
Red Light Bar Flashing: Cat detected in the unit for more than 30 minutes.
Red Ping Pong Light Bar: Motion detected in the drawer (see page 27).
Purple Light Bar Solid: Sleep Mode enabled, unit within the specied sleep period.
Red Light Bar Momentary Flash: Unit is in Control Panel Lockout Mode (see page 25).
Red Light Bar with Paial Yellow Flashing: Motor detected obstruction or jamming.
Red Light Bar with Paial White Flashing: Cannot detect Globe position. Unit will continue
to function in Automatic Mode. Contact Customer Experience.
Please refer to whiskersuppo.com/lier-robot-4 for the latest list of light codes based on
new rmware updates.
To Next Page
Loading...
Need help?
General
