To Next Page
M
Megan BrownSep 5, 2025
What to do if the controller set point is too high on my WhisperKool Platinum Split Wine Cooler?
- LLisa ArnoldSep 5, 2025
If the controller set point is too high on your WhisperKool Wine Cooler, lower the set point.
What to do if the controller set point is too high on my WhisperKool Platinum Split Wine Cooler?
If the controller set point is too high on your WhisperKool Wine Cooler, lower the set point.
What to do if my WhisperKool Platinum Split system is undersized for the cellar?
To address this, order the correct size system for your WhisperKool Wine Cooler.
What to do if the thermostat is not calling for cooling in my WhisperKool Wine Cooler?
If the thermostat isn't calling for cooling in your WhisperKool Wine Cooler, try lowering the set point.
What to do if the bottle is at set point in my WhisperKool Platinum Split Wine Cooler?
If your WhisperKool Wine Cooler bottle is at the set point, lower the set point to achieve a cooler temperature.
What to do if the Evaporator Unit is not plugged in WhisperKool Platinum Split Wine Cooler?
To resolve this issue, ensure that your WhisperKool Wine Cooler unit is plugged into an outlet.
What to do if something is blocking the air supply in my WhisperKool Wine Cooler?
If there's something blocking the supply and/or return air in your WhisperKool Wine Cooler, remove the blockage to ensure proper airflow.
How to increase humidity in my WhisperKool Air Cleaner cellar?
To increase the humidity level in your WhisperKool Air Cleaner cellar, raise the Fon setting.
Why does my WhisperKool Air Cleaner compressor short cycle?
Your WhisperKool Air Cleaner compressor might be short cycling if the evaporator blows on the bottle probe. To resolve this, move the bottle probe to a more central location.
Why is my WhisperKool Air Cleaner running but not cooling?
If your WhisperKool Air Cleaner is running but not cooling, it could be due to a few reasons. Check for any obstructions to the fan and ensure the evaporator filter, evaporator coil, and condenser coil are clean and free of debris to ensure proper air flow. If the compressor is overheating, shut the system off for 1 hour to allow it to cool, then turn it back on to check for cooler air flow. If the compressor runs, inspect and clean the condenser coil as a possible cause of overheating. If the problem repeats, contact your installing technician for assistance.
What to do if my WhisperKool Air Cleaner unit leaks water?
If your WhisperKool Air Cleaner is leaking water, several factors could be the cause. First, ensure the evaporator unit is level. Next, inspect the drain line for any clogs or kinks that may be obstructing water flow. Also, make sure the drain line has a consistent downward slope from the unit to the drain. If the coil is iced, melt the ice with a blow dryer and soak up the water with a towel. Finally, disconnect the drain and clear it out; open the access door and check the drain for blockages.
General| Brand | WhisperKool |
|---|---|
| Model | Platinum Split |
| Category | Wine Cooler |
| Language | English |
