Page 8
2010 Edition 1
WHYTE Service Manual
3.0: PREPARATIONS FOR RIDING
3.1: MAKING ADJUSTMENTS
Please refer to the specific component manufactur-
ers manual or published technical information
about adjusting the components on your Whyte
bike. Instructions may be downloaded from the
relevant manufacturer’s internet site, as shown in
the table to the right.
If you are uncertain in any way, about making ad-
justments to any components on you Whyte bike,
then DO NOT RIDE YOUR BIKE. Contact your
Whyte dealer who will be able to advise you on
how to go about setting up you Whyte for riding,
and or making adjustments to the components
fitted to your Whyte.
3.2: WHYTE GETTA-GRIP SEAT CLAMP
3.2.1: WHYTE GETTA-GRIP SEAT CLAMP SADDLE HEIGHT ADJUSTMENT
The Getta Grip seat clamp design is present on all models of Whyte full suspension moun-
tainbikes. It is a patented design to allow adjustment of the saddle height by either the use
of a QR Lever, or bolt-up method. This manual covers both of those styles of clamp design.
Item: Description
1 Seat Clamp Band
2 T-Pad
3 Main Frame
4 Barrel Nut
5 M6 x 30mm Fastener
6 M6 Washer
Fig.2: Getta-Grip Seat Clamp: Bolt-up
CST www.csttires.com
Easton www.eastonbike.com
Fi:zik www.fizik.it
Formula www.formulahubs.com
Fox www.foxracingshox.com
Shimano www.shimano.com
SRAM www.sram.com
Sun Ringle www.sun-ringle.com
TH www.thindustries.com.tw
VP www.vpcomponents.com
WTB www.wtb.com
To Next Page
Loading...
