Whyte Kynamic RHeO 1 - Page 34

34
Error Code Information Table:
Code Condition User Handling Dealer Handling
1 Hardware break • Please turn on and off for a few times
• Please contact your nearest service shop
• Please turn on and off for a few times
• Please return the controller to Brand/Kynamic Service
Center
2 Battery current over protection setting • Please contact your nearest service shop • Please check battery cable and connector to see if
there is abnormal and short-circuit condition
3 Phase current over protection setting • Please contact your nearest service shop • Please check motor cable and connector to see if
there is abnormal and short-circuit condition
4 Battery voltage over protection setting • Please contact your nearest service shop • Please check battery voltage
5 Motor hall sensor signal error or lost • Please contact your nearest service shop • Please check motor cable and connector to see if
connection is ne or short-circuit condition
• Please check hall sensor in the motor
6 Motor blocked • Please check motor and wheel if it is blocked
• Please check motor cable connection is ne
• Please check motor and wheel if it is blocked
• Please check if motor cable connection is ne
• Please check if torque sensor connection is ne
7 Torque sensor signal over protection setting • Please contact your nearest service shop • Please check if torque sensor connection is ne
• Please check torque sensor status
8 Torque sensor signal under protection setting • Please contact your nearest service shop • Please check if torque sensor connection is ne
• Please check torque sensor status
9 Torque sensor signal under protection setting • Please contact your nearest service shop • Please check if throttle connection is ne
• Please check throttle status
10 Throttle signal under protection setting • Please contact your nearest service shop • Please check if throttle connection is ne
• Please check throttle status
CHARGE LEVEL & ERRORS