USING SOUND ASSIST
All instructions are supported by illustrations found in the folded front and
back covers.
Pairing the device
Sound Assist must be paired to your hearing aids before you pair with
other devices.
Pairing to your hearing aids:
1. Make sure that Sound Assist is turned o.
2. Restart your hearing aids. The hearing aids will then be in pairing
mode for 3 minutes.
3. Press the volume up button (+) and the power/mode button (1.6)
simultaneously for 3 seconds until the in-use light indicators (1.5) are
glowing blue.
4. Make sure that the Sound Assist and your hearing aids are within 1 m
range of each other.
5. The pairing sequence will start automatically.
6. The in-use light indicators (1.5) will briefly flash green, when the
pairing is successfully completed.
The Sound Assist can only be paired to one set of hearing aids. To pair a
new set of hearing aids, you must perform the same steps and the new
pairing will overwrite the existing one.
Pairing to your smartphone or other device:
1. Turn o your Sound Assist.
10
To Next Page
Loading...
