widos 3511 - Maintenance; Storage; Transport; Maintenance; Storage; Transport.

Kunststoffschweißtechnik
WIDOS Einsteinstraße 5 Phone +49 (0) 71 52 / 99 39 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Fax +49 (0) 71 52 / 99 39 - 40
info@widos.de Internet: www.widos.de
20.08.14 Working instructions WIDOS 3511 Page 25 of 39
7. Maintenance / Storage / Transport
Goal of the chapter is:
 Keeping the nominal state and the operation capacity of the machine.
 Efficient planning of the maintenance works and the maintenance tools.
 Increasing the efficiency by avoiding non planned outage.
7.1. Maintenance
 Replace defective parts immediately, be especially careful with electric parts - dirt and
wetness are good current conductors.
 Use original WIDOS spare parts only.
 Prescribed maintenance and inspection works have to be carried out in time.
 According to DVS, inspection works are recommended after 1 year.
 At machines which are used more than average, the inspection cycle should be
shortened.
 The works have to be performed at the WIDOS company or at an authorized
partner.
7.2. Storage
 Keep the guide rods, toothed rods, toothed wheel and trapezoid spindle free from dirt and
covered with a thin oil film.
 Cover the machine during non-use.
 Store dry.
7.3. Transport
 The machine is transported in a transport box.
 Take care that the cable of the heating element is not squeezed.
 Protect the machine from heavy vibrations and shocks.
 Make sure that the box cover is correctly locked.
 Handle the machine carefully.
7.4. Cleaning of the machine
 The used materials and tissues have to be handled and disposed of properly, particularly
 when cleaning with solvents
 when lubricating with oil and grease