widos 5100 - Page 28

Kunststoffschweißtechnik
Foundation: 2207, 2208 DIN 16932 German association for welding
Use for:
5100
OD 200 - 450
5500
OD 200 - 500
1 bar on manometer:
141
N
PE 80
The value for heating element temperature is between 200° C - 220° C.
The
smaller
the pipe wall the
higher
the temperature.
PE 100
The standard value for heating element temperature is 220° C.
Increase the change-over time and the welding pressure time at PE 100 as fast as possible !
time to
change- reach full
over welding cool-down time
0,15 (PE) time pressure pressure in
T desired
temperature
time
pipe
pipe
SDR
bead-up
circular
heat-up
max.
time
welding
cool-
diameter
wall
pressure
bead
time
change-
to reach
pressure
down
OD
(s)
[bar]
min.
[s]
over
welding
[bar]
time
[mm]
[mm]
[mm]
time
pressure
[min]
[s] [s]

in welding area
Table for PE
bead-up heat-up
Additional to the given bead-up force and to the welding force the moving force of the support must be added !
welding area
P (N/mm²)
400
9,8 41 13 1,5 98 7 7 13 13
400
12,3 33 16 2,0 123 8 8 16 16
400
15,3 26,0 20 2,0 153 9 9 20 20
400
19,1 21,0 25 2,5 191 10 11 25 24
400
22,7 17,6 29 2,5 227 11 13 29 28
400
23,7 17,0 30 2,5 237 11 13 30 29
400
29,4 13,6 37 3,0 294 13 16 37 36
400
36,3 11,0 45 3,0 363 16 19 45 44
400
44,7 9,0 54 3,5 447 18 23 54 54
400
54,7 7,4 64 4,0 547 21 27 64 65
450
11,0 41 17 1,5 110 8 8 17 15
450
13,8 33 21 2,0 138 9 9 21 18
450
17,2 26,0 25 2,0 172 9 10 25 22
450
21,5 21,0 31 2,5 215 11 12 31 27
450
25,5 17,6 37 2,5 255 12 14 37 31
450
26,7 17,0 38 3,0 267 12 14 38 33
450
33,1 13,6 47 3,0 331 15 17 47 40
450
40,9 11,0 56 3,5 409 17 21 56 49
450
50,3 9,0 68 4,0 503 20 25 68 60
450
61,5 7,4 80 4,0 615 23 31 80 71
30.06.2011 Working instructions WIDOS 5100 Page 26/ 3 of 48