FOR YOUR SAFETY, READ BEFORE LIGHTING
I WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A.
B.
This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
BEFORE LIGHTING smell around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance or strike a match.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier'a instructions,
C.
D.
• If you cannot reach your gas supplier, call the fire
department.
Use only your hand to push in or move the selector
arm, Never use tools. If the arm will not push in or
move by hand, don't try to repair it, call a qualified
service technician. Force or attempted repair may result
in a fire or explosion,
Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
NOTES: FOR ADDITIONAL INFORMATION REFER TO THE INSTALLATION AND OPERATION INSTRUCTION MANUAL SUPPLIED
WITH THIS APPLIANCE OR CONTACT THE MANUFACTURER IDENTIFYING THE PRODUCT BY ITS MODEL NUMBER LOCATED ON
THE RATING PLATE, FOUND NEAR THE GAS VALVE.
LIGHTING INSTRUCTIONS
1. STOPT Read the safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. Remove control access panel.
5. From "ON" position, depress and move selector
arm on gas control to "OFF" position. Do not force.
GAS CONTROL
SELECTOR
ARM SHOWN
IN *OFF"
POSI'nON
6. Wait five minutes to clear out any gas, then smell for gas,
including near the floor. If you then smell gas, stop! Follow
"B" in the safety information above. If you don't smell
gas, go to next step.
7. Loosen wingnut and open pilot observation door (if
equipped).
8.
9.
10.
Find pilot--follow metal tube from gas control. The pilot
is mounted on side of burner.
Hold lighted match at pilot
burner.
Move selector arm to
"SET" position and light
pilot. Hold in "SET" position
for 1/2 minute after pilot is lit.
THERMO-_
COUPLE _
PILOT
NOTE: Sufficient time must be allowed BURNER
for pilot flame to heat thermocouple
and hold safety magnet in locked-up position.
Also, time must be allowed for air to be purged
from gas lines during first starting operation.
11. Release selector arm, and if pilot remains lit, move
selector arm to "ON" position.
• If the pilot will not stay lit after several tries, move
the selector arm to "OFF" and call your service
technician or gas supplier.
12. Close pilot observation door and tighten wingnut
(if equipped).
13. Replace control access panel.
14. Turn on all electric power to the appliance.
15. Set thermostat to desired setting.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be performed (if applicable).
3. Remove control access panel.
4. From "ON" position, depress and move selector arm on gas control to "OFF" position. Do not force.
5. Replace control access panel.
I
WARNING: DUE TO HIGH SURFACE TEMPERATURES -- KEEP CHILDREN, CLOTHING, I
I
FURNITURE OR ANY COMBUSTIBLE MATERIAL AWAY FROM FURNACE.
IMPORTANT: KEEP BURNER AND CONTROL COMPARTMENT CLEAN.
--27--
To Next Page
Loading...
