Williams 5508332 - Wiring Diagrams

Wiring Diagrams
FOR MODEL_
3508331 ond 3508332
FOR MODELS:
5508331 and 5508332
FOR 35M B.T.U.
FAN TYPE VENTED WALL FURNACE
WITH INTERMITTENT IGNITION CONTROL SYSTEM
L1 1.2
HOT 115V 80HZ NEUT
FAN SWITCH
115V
SENSOR•
@
TO + II
THERMOSTAT IGN
.v/Pv O _--r-_ O
Z4V/GNDO,
s_s O__ 0
PV O- 0
24V O"
MV O-
IGNO-
PV (P) 7
PVA=V(c)
_(_0
GAS
VALVE
IN1T-,RMI3'TENTIGN.
CONTROL MODULE
VENT
SAFETY
SHUT OFF
DE'V1CE
NOTES:
_FACTORy _ L_ VOLTAGE. 1 ffanyoftheoriginaJwireassupplied
-- FA_ WM_£D LOW VOLTAGE. withthe appliance has to be replac-
1//4 QUICK CONNECT "I_RMINAL ed, useonly 18Ga.,4/64insulation,
FACTORY WIRING. 105 ° C. AWM copper wire or its
V4RE CONNECTOR FOR FAC'F(_Y equivalent 115V-60Hz.-lessthan
_R_O LINE VOf.TA_- 3 amps.
2. MOTOR IS THERMALLY OVER-
(_ SCREW "J_E_NAL LOW _31.TAGF-
LOAD
PROTECTED.
115V. 60Hz - LESS THAN 3 AMPS
FOR 55M B.T.U.
FAN TYPE VENTED WALL FURNACE
WITH INTERMITTENT IGNITION CONTROL SYSTEM
L1 • 115V BOHZ _ 19
FAN _TCH _TGPI 'v' 3 _ w _L COM
TR_S. FLAME
UMIT SWITCH r'mor_ • SENSOR
+1
i I_10 O i
z4v/mD 0 , ,
SENS 0 -- _; PV/_IV (C)
PV 0 MV (M)
24V 0 _ GAS
Mv0 L VALVE
IGN0 ---
IN'W.RMITW.NT IGN.
CONTROL MODULE
VENT
SAFETY
SHUT OFF
DE_CE
LE_ NOTES:
m FACTORY _ LINE VOLTA_-. 1. Ifanyoftheoriginalwireassupplisd
-- FACTORY _ LOW VOLTAGE. withtheappliancehastobereplac-
I/4. QUICK CONNECT "I_UNAL ed, useonly 18 Ga., 4/64 insulation,
FOR FACTORY V_RtNG. 105° C. AWM copper wire or its
_RE CONNECTOR FOR FACTORY equivalent 115V-60Hz.-lessthen
'_4RINQ LINE VOLTAGE* 3 amps
2. MOTOR IS THERMALLY OVER-
SCREW/ _ LOW _OLTAGE, LOAD PROTECTED.
115V 60Hz - LESS THAN 3 AMPS.
"n-IERMOSTAT r_] cONV-oUR-ET
D
"THERMOSTAT _ CONV.OU'I1..ET
D
-- 2"-'ff49-
T
'= "l
SPNtK GAP
-- ARK
7/'G:2- oTR
uv (_)
_1 VENT SAFETY
NTERMIT_T IGNITION CONTROL MODULE SHUT OFT"DEVICE
__ 7/a,r --FSPA_K S_TCH
_1 / ELECTRODE
@
--_ I'_ -uv(M) ._=i_
-- "_R-- BLACK 't/
w--Qg- .,
_QN "1, VENT SAFETY
Z]N'R_MIT'Jl_T IGNITIONCON_I_OLMODULESHUT OFF DEVICE
--37--