FOR YOUR SAFETY, READ BEFORE LIGHTING
I WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
B. BEFORE LIGHTING smell around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than sir and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance or strike e match.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor's
phone, Follow the gas supplier's instructions.
C.
D.
• If you cannot reach your gas supplier, call the fire
department.
Use only your hand to push in or move the selector
arm. Never use tools. If the arm will not push in or
move by hand, don't try to repair it, call a qualified
service technician. Force or attempted repair may result
in a fire or explosion.
Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
NOTES: FOR ADDITIONAL INFORMATION REFER TO THE INSTALLATION AND OPERATION INSTRUCTION MANUAL SUPPLIED
WITH THIS APPLIANCE OR CONTACT THE MANUFACTURER IDENTIFYING THE PRODUCT BY ITS MODEL NUMBER LOCATED ON
THE RATING PLATE, FOUND NEAR THE GAS VALVE,
LIGHTING INSTRUCTIONS
1, STOP! Read the safety information above,
2. Set the thermostat to lowest setting.
3, Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
5. Remove control access panel.
6. From "ON" position, depress and move selector arm on
gas control to "OFF" position, Do not force.
GAS CON'n_OL
SELECTOR
ARM SHOWN
IN "OFF"
POSI'NON
Wait five (5) minutes to clear out any gas, then smell for
gas, including near the floor. If you then smell gas, stop!
Follow "B" in the safety information above. If you don't
smell gas, go to next step.
8. Move selector arm to "ON" position.
9, Replace control access panel.
10, Turn on all electric power to the appliance.
11. Turn thermostat to "ON" (HEAT) position. Set thermostat
higher than room temperature. Pilot will automatically
light and main burner(s) will light in approximately 45
seconds,
12.
13.
14.
NOTE: On initial start-up or after prolonged shut down,
several ignition cycles may be required to purge gas
lines. To accomplish the recycle - repeat steps 6
through 11 until pilot is established.
Set thermostat to desired setting.
After the room thermostat turns the system off, a delay
of approximately one minute is required before the
system can be turned on again.
If the appliance will not operate, follow the instructions
"To Turn Off Gas To Appliance" and call your service
technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be performed.
3. Remove control access panel.
4. From "ON" position, depress and move selector arm on gas control to "OFF" position. Do not Force.
5. Replace control access panel.
WARNING: DUE TO HIGH SURFACE TEMPERATURES -- KEEP CHILDREN, CLOTHING,
FURNITURE OR ANY COMBUSTIBLE MATERIAL AWAY FROM FURNACE.
IMPORTANT: KEEP BURNER AND CONTROL COMPARTMENT CLEAN.
--30--
To Next Page
Loading...
