Caution
About the Installation
Warning:
Accessories
Projector Lens Cover Remote Controller Power Cable
AV Cable User Manual Cloth HDMI Cable
Back-up Protective Tube AV Converting Cable
x1
x1x1
Screws
x4
x1 x1 x1 x1
x1 x1 x1
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
17 18 19 20
21
22 23 24 25
26 27 28 29
30 31 32 33
34 35 36 37
38 39 40 41
42 43
44 45 46
47 48 49
50 51 52 53
54 55 56 57
58 59 60 61
62 63
64 65 66 67
68 69 70 71
72 73 74 75
76 77
In order to improve the projector’s service life, it should not be in a place
of wet and poorly ventilated condition.
Do not place the projector under direct sunlight.
Projector working temperature: 0℃~ + 35℃
Projector store temperature: -10℃~ + 60℃
Do not block air intake and air exhaust.
If the projector interior temperature is too hot, the projector will be shut
o automatically. This is due to the heat protection system. So please
clean the lter of projector once a month. It is very important. Do not
remove the power cord immediately after shutting the projector down,
allowing 5 minutes for it to cool down.
Fans will adjust according to temperature; it is controlled by the system.
When the projector is working, the fans turn slowly or quickly, therefore the
sound of the fans will be dierent. This is normal.
Do not remove the power plug when the projector is working, it will cause
the fans to stop working and the projector overheating and this may cause
damage to the projector.
To Next Page
Loading...
