- TNC: In TNC mode you have three options.
1. Via USB-C Virtual Com Port
2.TCP. PicoAPRS supports DNS-SD Discovery
3.Bluetooth (Classic)
In all three variants, your PicoAPRS works as a "KISS" TNC.
Brightness
Brightness controls the display brightness.
The gray bar shows the set brightness.
Brightness is adjusted with the up and down
buttons.
GPS Powersave
„GPS Powersave“ defines whether the GPS
receiver should be switched off automatically when
GPS is not needed.
"OFF" turns off the power saving function and
"ON" enables this function.
www.wimo.com - 20- ©Taner Schenker, 13. December 2022
If the external power supply is connected via
USB, GPS is activated regardless of this setting!
If the GPS receiver is deactivated cyclically, this saves energy and extends the battery
life. On the other hand, the GPS speed may not be displayed correctly on the main
screen. In addition, the distance to other stations is then only calculated and displayed
using the last known GPS position.
A low brightness lowers the power consumption and
thereby extends the battery life slightly.
To Next Page
Loading...