Windhager LogWIN LWP 180 - Actuator Test; Installation of Mes Modules

30
For the Service Technician
4.5.5 Actuator test
The following actuators can be selected with the arrow buttons, then confirmed
and started using the Choose button. The actuators are switched off again after
1 minute. A self-test is started at the end of an actuator test.
– Induced draught fan
– Primary airflap
– Secondary airflap
– O2 heating
4.5.6 Installation of MES modules
Display if an MES module is installed (connected) or uninstalled (disconnect-
ed) – Fig. 69.
Fig. 68
Fig. 69
Induced draught fan
Primary airflap
Secondary airflap
O2 heating
Choose Back
Installation procedure
active
.....
(Animated symbol)
4.5.4 Language
Selection of “Language” for the display texts on InfoWIN.
Fig. 67
Language
Deutsch
English
Française
Italiano
Castellano
Choose Back