System example with
WSC 320
Smoke ventilation panel (20A) with 2 smoke
zones.
The keypads and smoke detectors are cabled
directly to the break glass units in the smoke
zones, which means that the need for cabling in
the building is significantly reduced.
A wind/rain sensor is connected to close the
windows during comfort ventilation in case of
high wind and/or rain.
The smoke ventilation panel is connected to the
Fire Alarm System via the WCA 3SS card.
Number of motor lines and other functions
Standard version
2 motor lines
2 keypads / inputs
Standard version
2 motor lines
2 keypads / inputs
The standard version of the panels have 16 DIP switches for easy configuration of the panel, see section 11 for further
information.
3.1 Max numbers of actuators per motor line and panel
The table shows the maximum number of actuators, which can be connected per motor line and panel depending on the type of the
actuators, panel and connected cards. The total power consumption of all the connected actuators must not exceed 10A or 20A
depending on panel size.
WSC 320 with 20A includes up to two motor lines each with 10A. If there is a need of more than 10A on one motor line, DIP switch
2.6 is set to 20A. Hereafter one motor line can be loaded with 20A or two motor lines can loaded up to a total of 20A e.g. 17A and
3A.
To Next Page
Loading...