Step 3 – Next, with the provided two wire nuts, splice the included 9.5" power
cable and the power cable that the RV Manufacturer installed. Connect the
black wire and the ground wire from the RV, and the red wire to the power
wire from the RV. Ensure that the cables are secure to the wire nuts before
continuing. Continue to Step 13 if the power cable was already installed.
Discard the included wall plate and power switch, if not needed.
NOTE: If the power wire was not installed, you will need to install your own
power wire. It is recommended to use 18 gauge wire no longer than 50 feet
with a dedicated 12VDC circuit and a 3A fuse. See the Air 360
+
installation
manual for more information.
Step 4 – Choose a location to install the supplied Wall Plate with Power On/
Off switch. When selecting a location, remember that a +12VDC power cable
will need to be run from the Gateway to the switch.
Step 5 – For a wall or panel mount, drill or use
a hole saw to create a 1¼" hole. Pull the power
cable from the Gateway and the RV’s power wires
through the wall or panel.
Step 6 – Be sure the switch is in the OFF position
before continuing. Slide the power switch into the
wall plate.
Step 7 – Connect the +12V power wire from the
vehicle to a small red terminal insulator. Crimp
the connector.
Step 8 – Connect this small red terminal insulator
to the isolated spade of the power switch.
Step 9 – Connect the red wire from the Gateway
to the other small red terminal insulator. Crimp
the connector.
Step 10 – Connect this small red terminal insulator
to the middle spade on the switch.
Installation (cont.)
On/Off rocker
wwitch (shown
in Off Position)
+12 V
from
vehicle
+12 V
from Air
360
+
Barrel crimp splice
ON
Power switch into
wall plate
3
To Next Page
Loading...
Need help?
General
