Maintenance6708−1/A2
RT-flex58T-E
Winterthur Gas & Diesel Ltd.
2/ 3
3. Removal
Remark: If the water separators must be dismantled above the supply unit, the half
close to the free end must be removed first!
⇒ Open hinged cover 4 and door 16 (Fig. ’A’).
⇒ Remove screws 4 and intermediate flange 5.
Risk of accident! Before removing screws 5, it must be ensured that intermediate
flange 6 (26 kg) cannot fall down!
⇒ Remove screws 7 together with spring washer 8 and tension sleeves 9.
⇒ Remove screws 10 and put both covers 11 with their air flaps fitted (approx. 47
kg each) on the bottom of receiver 1.
⇒ Fasten manual ratchets ’H1’, connect and tighten it with the water separator.
⇒ Remove screws 12 together with sleeves 13, pressure springs 14 and discs
15.
⇒ Lower water separator.
B
I
I - I
I
018.195/09
19
10
11
3
12
H1
4
1
1413
15
5
7,8
936
19
2013
Maintenance of Water Separator 2-part Water Separator
To Next Page
Loading...
