Maintenance
0380−1/A1
RT-flex58T-E
Winterthur Gas & Diesel Ltd.
7/ 8
Group Component Work to be carried out Intervals
8733−1 HP pipe to
injection valve
(on cylinder cover)
− Regrind sealing faces as required
Non-return valve − Random check 18 000 Op.h
8744 Supply unit fuel
drain piping
− Check regularly for free passage at least once a
year
6000 Op.h
8752−1 HP fuel pipe − Regrind sealing faces as required
9
9223−1 Crank angle
sensor unit
− Check tension visually
Check cracks and wear of tooted belt visually
Visual lubricating oil check
3000 Op.h
− Replace toothed belt 24 000 Op.h
− Overhaul drive (ball bearing, sealing ring etc.)
and check shaft eccentricity of CAS drive
48 000 Op.h
− Check shaft eccentricity of CAS drive at every CAS exchange
− Replace crank angle sensor 48 000 Op.h
(only if new soft belt is
applied from beginning)
Oil mist detector − Follow manufacturer’s instructions half yearly
WECS electronic
components
− Replace FCM−20, ALM−20, ACM−20 modules
(see Operating Manual 4002−4)
36 000 ... 50 000 Op. h
− Check cabling and wiring. Replace damaged
cables and wires
quarterly
V2 / 2013
Inspection and Overhaul Intervals (Guidelines)
To Next Page
