Maintenance0380−1/A1
RT-flex58T-E
Winterthur Gas & Diesel Ltd.
8/ 8
The indicated maintenance intervals must be taken as guidance and may vary
depending on the installation. The proper intervals are subject to the points men-
tioned below. Experience will show whether these intervals can be extended or
must be shortened.
− Environmental and operating conditions
− Heavy fuel oil and lubricating oil qualities (see Operating Manual 0710−1 and
0750−1)
− Engine load
− Fuel, lubricating oil and cooling water care (see Operating Manual 0720−1
and 0760−1)
− Overhaul according to Maintenance Manual
− Genuine spare parts used
− Engine monitoring
− Engines according to specifications of Wärtsilä Switzerland Ltd.
On the engine sectional drawings 0803−1, those parts are marked with group
numbers, as they are found in the Maintenance Manual.
Group numbers exist of the following engine components, although these parts
are not marked on the sectional drawings:
Engine Control System WECS
Control works in the WECS (Wärtsilä Engine Control System) are described in the
following groups of the Operating Manual:
− Regular checks and recommendations 4002−4......................
− Engine control 4003−1............................................
2013
Inspection and Overhaul Intervals (Guidelines)
To Next Page
Loading...
