Page 16
Winkhaus STV
Operating Manual EAV 0124653 0505
Subject to technical changes
Winkhaus STV GmbH & Co. KG · Berkeser Str. 6 · D-98617 Meiningen · Germany · www.winkhaus.de · stv@winkhaus.de
Frame element:
• Drill a hole with a of 6 mm [0.236“] through the
door frame.
• Pass the cable through the door frame.
• Fasten the element with the fitting screw [1] having a
of 4 x 25 mm [0.984“].
Sash element
• Drill a hole of 13 mm [0.512“] through the
fitting groove up to the glass groove.
CAUTION!
The bore hole must be burr-free. The spring
must be under a slight pre-tension even with
the door being closed.
• Pass the cable with the plug for the motor box
through the door sash.
• Insert the end of the spring into the hole in the door
sash.
• Fasten the element in the fitting nut by using the
fitting screws [2] having a of 4 x 25 mm [0.984“].
• Install the cable for example within the glass groove
towards the motor box; install the rest of the cable
for example within the hollow cell.
3.2. Cable transition KÜ-T STV (plug-in)
Installation sequence:
NOTICE!
Provide a cable reserve of about 3 - 5 cm [1.181 - 1.969“] for the spring
tension behind the sash element of the cable transition.
• Establish the plug-in connection after putting the door on its hinges.
• Fix the plug with the fitting screw [3] having a of 4 x 25 mm [0.984“].
CAUTION!
Recommendation: Do not mount the second retaining screw [3]
before having installed the door frame into the wall reveal.
CAUTION!
Insulate the wires not used!
3. Installation
To Next Page
Loading...