Pergola SO! | User manual
Mold formation on the wood
Thermowood is not susceptible
for fungal growth from inside
out. It is possible that air-borne
molds adhere to the surface of
the wood.
This can be removed with a
solution of 50% bleach and
50% water. Rinse afterwards but
be carefull to not damage the
screenfabric. After drying apply
a protective hydroblock layer.
Color difference on the wood
All woods are subject to dis-
colouration due to the sun. If
something stands in front of
the wooden panels, this can
lead to a color difference after
Make sure that all the panels
receive the same amount of
light. The colourisation will be
less if the wood panels are on
the inside of the pergola.
Consult your installer in case of other errors
5.6. Repairs:
Repairs may only be carried out by your certified dealer
5.7. Recycling:
This pergola may only be disassembled by an experienced professional
• Disconnect from power supply
• Carry out the disassembly in the reverse order of the assembly
• Make sure that components do not fall down uncontrolled during the disassembly
• Observe the local environmental conditions
• Metal components can be recycled without a loss of properties
Rev. 16:24 18/03/2023
Page 18/27
Winsol | Sun protection
EN
2023
To Next Page
Loading...
