NOTICE
Original SmartPAC or SmartPAC 2 Initialization settings cannot be restored to SmartPAC PRO
using SBR. Be sure to copy Initialization settings to a paper form or take photos before the backup
so you can enter them manually into SmartPAC PRO after you have restored the tool settings.
Also, delete any obsolete tools before backup.
Copy the following settings listed below to a paper form or take photos before the backup. You don’t
need to record settings for AutoSetPAC, WaveFormPAC, ProPAC, or RamPAC, since this
information is stored at the PAC.
• Position Sensor (If Installed): Enabled or Disabled
• Counter Setup Mode: Incremented in All Modes or Not Incremented in Inch Mode
• Press Name
• Brake Monitor: Stop and Start Time Limits
• Custom Cam Names
• Auto Advance Settings (If Used)
• Custom Sensor Names
• Sensor Enable Mode: Manual Enable, Auto by Tool, Auto by Sensor
• Setup Mode: Inch or Disabled
• Tool Information
• Security Access: All Settings
• Installed Options (if applicable): Settings for SFC (Set Communications), PM Monitor, SFI,
MultiPAC
You don’t need to record settings for AutoSetPAC, WaveFormPAC, ProPAC, or RamPAC (Note:
This information is stored at the PAC).
Backing Up the Tools on Your Existing SmartPAC
Use one of the methods below to back up (copy) the tool settings from your existing SmartPAC.
• If your existing unit is a SmartPAC 2 with the BACKUP/RESTORE installed option, back up
(copy) the tools onto a USB drive according to Using the SmartPAC 2 USB Disk
BACKUP/RESTORE Installed Option to Back Up Tools, below.
• If your existing SmartPAC is either an original SmartPAC or a SmartPAC 2 without the
BACKUP/RESTORE installed option, back up (copy) the tools onto a USB drive according to
Appendix A – Backing Up Tools Using SmartPAC Backup and Restore (SBR), page 16.
To Next Page
Loading...
Need help?
General
