Upgrading from Original SmartPAC or SmartPAC 2 to SmartPAC PRO 1145200
Instruction Sheet 3
Using the SmartPAC 2 USB Disk BACKUP/RESTORE Installed
Option to Back Up Tools
NOTICE
These instructions require the SmartPAC 2 firmware to be V10.08 or higher and have the USB
Disk Backup as an installed option. If your unit does not have this installed option contact your
Wintriss Rep or Wintriss Customer Service department for upgrade and ordering information
(Installed USB Disk Backup - P/N 9679619).
NOTICE
Original SmartPAC or SmartPAC 2 Initialization settings cannot be restored to SmartPAC PRO. Be
sure to copy Initialization settings to a paper form or take photos before the backup (Recording
SmartPAC Initialization Settings Before Upgrading, above) so you can enter them manually into
SmartPAC PRO after you have restored the tool settings.
You should delete any obsolete tools before performing the backup.
Back up your tools on a USB disk using the BACKUP/RESTORE feature on the Initialization Menu.
Follow the instructions in Backing Up Tools to a USB Disk in Chapter 4 of your SmartPAC 2 User
Manual. After you back up the tool information to the USB disk, proceed with your SmartPAC PRO
upgrade.
Keep the USB drive in a safe place until ready to load into your SmartPAC PRO.
NOTICE
If you are upgrading an original SmartPAC or a SmartPAC 2 without the BACKUP/RESTORE
installed option, back up the tool information according to the instructions in Appendix A – Backing
Up Tools Using SmartPAC Backup and Restore (SBR), page 16.
Removing Your Existing SmartPAC
NOTICE
Before removing your existing original SmartPAC or SmartPAC 2, back up your tool data and
record the installation settings as described in Recording SmartPAC Initialization Settings Before
Upgrading, page2.
To uninstall your existing SmartPAC, follow these steps:
1. Mark cables and disconnect terminal blocks from the terminal block connectors. Remove from
your existing unit.
2. Remove and set aside in a safe place any PAC modules from your existing SmartPAC
3. Remove mounting fasteners and remove SmartPAC control enclosure or panel mount unit.
To Next Page
Loading...
Need help?
General
