Withings Aura - Page 51

EN-51
Withings Aura
v2.0 | July, 2015
12. Tap Done.
The calibration of your sensor starts. This step can last up to 10 minutes during
which a LED is lit up and a buzzing sound can be heard. Do not sit on the bed
while the LED is on. It will automatically switch o when you can start using the
sensor.
Installing your Sleep Sensor on a separate account
If you have two Sleep Sensors, you can either install both of them on the same
Withings account, or install them on separate accounts. To install the second
sensor on another account, perform the following steps:
1. Log in to the Withings Health Mate app as the user of the second sensor.
2. Install your Connected Alarm Clock on this account.
Refer to “Installing your Connected Alarm Clock with no existing account”
on page12 or “Installing your Connected Alarm Clock with an existing
account” on page17 for more information.
3. Install your Sleep Sensor.
Refer to “Installing your Sleep Sensor at the same time as your
Connected Alarm Clock” on page44 for more information.