Operating Manual V-Drive
+
/V-Drive economy
Page en-20
Index: 11 2022 D005924 Release: 30.04.2019
8.4 Start-up after maintenance work
Clean the outside of the gear reducer.
Assemble all safety devices.
Do a test run, before re-releasing the machine for operation.
8.5 Malfunction list (troubleshooting)
Seek an immediate solution if you notice oil loss, increased noise during operation or
higher operating temperatures.
Malfunction Possible cause Solution
Higher operating
temperature
Dimensioning
insufficient
Check the technical data
Motor heating the
gearbox
Check the wiring of the motor, replace the
motor or install insulation between motor
and gearbox
Ambient temperature
too high
Ensure adequate cooling
Oil quantity too high Correct the oil level
Attention
The gearbox can be damaged if
the oil level is too low.
Do not allow too much oil
to drain off.
Increased noise
during operation
Damaged bearings Please consult our Customer Service
Department.
Damaged gear teeth
Oil loss Sealings not tight Please consult our Customer Service
Department.
Table 8.3
9 Dismantling
Please observe the instructions in the „General Safety Instructions” in section
3.3.1.
9.1 Preparation
Shut down the machine in which the gearbox is installed.
Make sure that it is possible to dismantle the gearbox without the risk
of damage to the entire machine.
Before starting work, disconnect the machine from the mains.
9.2 Disassembling the gearbox
For gearboxes with motor mounting, disconnect the electrical connections
of the motor.
Secure the gearbox so it cannot fall.
Release the screws connecting the gearbox to the machine.
Remove the gearbox from its position with great care, so as to safeguard
the gearbox and adjacent parts against damage.
To Next Page
Loading...