EasyManuals Logo

WiXHC MK IV Series User Manual

WiXHC MK IV Series
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
Wiring diagram
4.3.2 Spindle driver
REV
PWM
FWD
0V
10V-in
AVI
0V
PUL+(5V)
PUL-
DIR+(5V)
DIR-
﹢
﹣
DC5V power
Spindle connect stepper or servo driver, you need a 5V
power supply, wiring as shown below
Driver
Control Board
11

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WiXHC MK IV Series and is the answer not in the manual?

WiXHC MK IV Series Specifications

General IconGeneral
BrandWiXHC
ModelMK IV Series
CategoryController
LanguageEnglish

Related product manuals