WiXHC MK IV Series - Page 3

5.3 Jog move
5.9 Z Auto Tool Zero
5.4 Go to Home of machine
5.5 Go to Zero
5.7 Load G code
5.6 Manual input G code
5.8 How to control output ports
22
23
23
24
25
24
26
6.3 Software limit
6.4 Driver plug-in control
6.5 Z safety height
6.6 Motor direction of go to Home
6.7 General Config
6.2 Ports and Pins
6.2.1 Motor outputs
6.2.2 Input signals
6.2.3 Output signals
6.2.4 Spindle setup
6. Mach3 Software parameters
6.1 Motor tuning
28
28
29
29
29
30
31
32
33
34
35
36
5.2 Spindle On/Off
21