88
User Manual WMF1100 S
Care | Manual cleaning
After 5hours, clean all parts thoroughly with
abrush
Rinse all parts very thoroughly with clear drinking
water
Health hazard/hygiene
> The trim strip on the spout can be removed
and cleaned if needed.
Burn hazard/scalding hazard
• The steam nozzle can blow out hot steam
without the milk foamer.
> Never install the steam nozzle without
amilkfoamer.
Assemble the milk foamer
Do not grease the parts for assembly, just get
themdamp.
Assemble the parts and press them in tightly
Replace the milk foamer in the spout
Clean the milk hose
Immerse one end of the milk hose in the cleaning
solution with the other parts
Immerse the length of the remaining milk hose in
the cleaning solution
This procedure prevents air bubbles from remaining in
the milk hose.
All parts must be completely immersed in the cleaning
solution.
CAUTION
Follow the Safety chapter
w starting on page 7
CAUTION
Follow the Safety chapter
w starting on page 7
“Cleaning the milk hose” instructions
w Instructions
page 43
Clean the milk hose