SAFETY
Use Proper Maintenance Procedures
2
2-5 EGdoc082610 Safety
Use Proper Maintenance Procedures
DANGER! Make sure all electrical installation, service and/or
maintenance work is performed by a qualified electrician and is in
accordance with applicable electrical codes.
DANGER! Hazardous voltage inside the electric boxes and at the
motor can cause shock, burns, or death. Disconnect and lock out
power supply before servicing! Keep all electrical component covers
closed and securely fastened during machine operation.
WARNING! Consider all electrical circuits energized and dangerous.
WARNING! Disconnect and lock out power supply before servicing!
Failure to do so may result in serious injury.
WARNING! Never assume or take the word of another person that the
power is off; check it out and lock it out.
WARNING! Do not wear rings, watches, or other jewelry while working
around an open electrical circuit.
IMPORTANT! Edger is equipped with two emergency stop buttons -
one at the front, the other at the rear of the machine. They are used to
immediately stop the motor and/or Edger operation in hazardous
situations. The emergency stop buttons should always be in proper
condition.
!
To Next Page
Loading...
