Wood-mizer LT20 Series - Adjusting Bed Rails to the Blade

SAWMILL ALIGNMENT
Adjusting Bed Rails To The Blade
SAWMILL ALIGNMENT doc052711 5-12
5
See Figure 5-11.
5.6 Adjusting Bed Rails To The Blade
1. Adjust the front pivot bed rail 90
o
to the main bed tube.
2. Move the cutting head to center the blade over the front pivot bed rail.
3. Measure the distance from the top of the pivot rail to the bottom of the blade. Make this
measurement at each end of the pivot rail.
4. The two measurements should be 15” (375 mm).
5. Loosen the locking set screws and turn the inner height adjustment nut to adjust the height of the
inner end of the pivot rail.
See Figure 5-12.
FIG. 5-11
FIG. 5-12
Stop Screw
Inner Height
Adjustment
Nut
Outer Height
Adjustment
Bolt
SM0134
15" (375mm)
to blade
15" (375mm)
to blade