SAWMILL ALIGNMENT
Vertical Adjustment of Side Supports
SAWMILL ALIGNMENT doc052711 5-28
5
5.17 Vertical Adjustment of Side Supports
1. Place a flat board across the bed rails.
2. Swing a side support up so that it is vertical.
3. Pull back at the top of the support to eliminate slack as if a log were being clamped against it.
See Figure 5-25.
4. Check the angle of each support with a square on the board.
5. The side support should be 90
o
to the bed rails or leaning forward 1.0 mm (0.04"). Loosen the top
adjustment bolt, adjust the side support, and retighten the bolt.
6. Repeat for the remaining side supports.
FIG. 5-25
To Next Page
Loading...
