Wood-mizer LT40 Series - Autoclutch Option Adjustment

Maintenance
Autoclutch Option Adjustment
3
3-12 HDdoc012020 Maintenance
3.13 Autoclutch Option Adjustment
If your sawmill is equipped with the Autoclutch option, check the clutch linkage after every drive belt or brake
strap adjustment.
1. Remove the blade from the sawmill.
2. Remove the inside belt guard and push the Autoclutch switch up to engage the drive belts.
3. With the belts engaged, place a straight edge between the upper and lower clutch pivot centers. Measure the
distance to the middle pivot.
4. Adjust the Autoclutch turnbuckle so the middle pivot is positioned 7/16” behind the straight edge.
See Figure 3-11.
FIG. 3-11
3H0505
Remote Clutch
Turnbuckle
7/16"
Upper Pivot
Lower
Pivot
Straight
Edge
Upper Pivot
Remote Clutch
Turnbuckle
Straight
Edge
Lower
Pivot