Operation
Locking Pin Operation
1
1-26 WM doc 12/19/19 Operation
SECTION 1 OPERATION
1.1 Locking Pin Operation
WARNING! Turn the base unit’s power to OFF, remove the key, and
disconnect the battery ground terminal, if applicable.
Insert the locking pin to lock the debarker in place when transporting the sawmill.
Remove the locking pin during sawing operation. See Fig. 1-0.
1.2 Control Overview
The Debarker Option allows you to remove bark from logs ahead of the bandsaw blade.
This prevents the bandsaw blade from contacting dirt, sand, or other debris in the bark
that can dull the blade.
See Figure 1-1. The debarker control includes two toggle switches, an indicator light, and
FIG. 1-0
To Next Page
Loading...
