Wood-mizer MP180 E6S - Page 28

SETUP & OPERATION
Planning / Thicknessing
3
3-8 EGdoc052521
 The thicknessing depth is adjusted with the crank (J). The set thickness can be read on the
scale (K). The thicknessing depth can be adjusted from 0.3 mm to 4 mm. The maximum depth
can be set for the material width not bigger than 160 mm. Always measure the material and
adjust the height before thicknessing.
See figure 3-7.
FIG. 3-7 MP180
Bottom Table
Height Scale (K)
Bottom Table Height
Adjustment Crank (J)