30 Assembly
MAN1298
(
08/01/2023
)
INSTALL DRIVELINE
(Figure 29)
Select either the standard shear bolt or optional slip
clutch driveline.
Shear Bolt Driveline
■ A grade 2 bolt must be used for the shear bolt to
provide gearbox protection.
1. Position clutch shield (1) against gearbox. Secure
using cap screw (2), lock washers (3), and at
washers (4). Torque hardware to 12 lbs-ft.
2. To prevent seal damage, carefully push driveline(6)
onto gearbox input shaft until it contacts the gear-
box housing.
3. Place retaining ring (5) in slot on input shaft and
snap into place.
4. Align the holes in the driveline (6) yoke and gearbox
input shaft. Install and tighten shear bolt (7) and nut
(8).
5. Lubricate rear driveline half and install front drive-
line half.
Driveline Slip Clutch
■ A grade 8 bolt must be used to attach clutch
driveline to gearbox.
A new slip clutch, or one that has been in storage over
the winter, may seize.
1. Before operating slip clutch, make sure it will slip.
Refer to Slip Clutch Adjustment, page 19.
2. Position clutch shield (1) against gearbox. Secure
using cap screw (2), lock washers (3), and at
washers (4). Torque hardware to 12 lbs-ft.
3. Install driveline (9) onto gearbox input shaft and se-
cure with bolt (10) and nut (8).
4. Lubricate rear driveline half and install front drive-
line half.
Figure 29. Shear Bolt and Slip Clutch Assembly
NOTICE
NOTICE
1
4
3
2
6
7
5
CD8112
1. Clutch shield
2. 5/16 NC x 3/4 Cap screw
3. 5/16 Lock washer
4. 5/16 Flat washer
8. 1/2 NC Lock nut
9. Slip clutch driveline
10. 1/2 NC x 3 Socket head
cap screw GR8
To Next Page
Loading...
