Woods RC42.20 - Transportation; Storage

Safety 9
MAN1298
(
08/01/2023
)
■ Your dealer can supply original equipment hy-
draulic accessories and repair parts. Substitute
parts may not meet original equipment speci-
cations and may be dangerous.
■ Tighten all bolts, nuts, and screws to torque
chart specications. Check that all cotter pins
are installed securely to ensure equipment is in
a safe condition before putting unit into service.
■ Make sure all safety decals are installed.
Replace if damaged. (See Safety Decals section
for location.)
■ Make sure shields and guards are proper-
ly installed and in good condition. Replace if
damaged.
■ Service and maintenance work not covered in
OWNER SERVICE must be done by a qualied
dealership. Special skills, tools, and safety pro-
cedures may be required. Failure to follow these
instructions can result in serious injury or death.
TRANSPORTATION
■ Disengage the PTO and wait for all moving parts
to come to a complete stop. Raise the tractor
3-point arms to bring the cutter into transport
position.
■ With cutter adjusted to transport position, set
upper stop on tractor lift quadrant to prevent
cutter from contacting driveline while being
raised.
STORAGE
■ Keep children, bystanders and animals away
from equipment and storage area.
■ Disconnect cutter driveshaft and secure up off
ground. Raise cutter with 3-point hitch. Place
blocks under cutter side skids. Lower cutter
onto blocks. Disconnect cutter from tractor
3-point hitch and carefully drive tractor away
from cutter.
SAFETY RULES
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!