39PN-52886 (4/97)
Ref Part
No No Description
1 37009 7/8--18 UNF Hex jam nut
2 10378 1/4 NC x 1 Hex head cap screw GR5
3 52898 .929 x 1.41 Lockwasher
4 1985 1/4 Standard lockwasher
5 34440 H 1 ” Straight bore bushing with key P.I.
6 66694 Sheave (RD6000) -- o r --
6* 12622 Sheave (RD7200) -- o r --
6 53419 Sheave (RD8400)
7 52881 Spindle assembly
8 52949 Seal
9 52872 Sleeve
10 29899 Bearing cone
11 52882 Blade spindle housing with cups
12 29898 Bearing cup
14 52852 Spindle shaft with keyway
16 1001513KT CW High-suction blade, standard (set of 3)
(RD60000 with double--bolt blades) -- o r --
16* 58731KT CW High-suction blade, standard (set of 3)
(RD7200 with double--bolt blades) -- o r --
16 53417KT CW High-suction blade, standard (set of 3)
(RD8400)
19 4358 1/2 NF x 1-1/4 Hex head cap screw GR5
21 1972 1/4--28 Tapered thread grease fitting
22 3379 1/2 NC x 1-1/2 Hex head cap screw GR5
23 11900 1/2 NC Hex flange locknut
* Used for RD7200 mowers SN--688691 and after. These
mowers use two capscrews and locknuts to attach the
blade.
CD5055
22
23
8
SEAL LIP
21
3
1
6
5
4
2
SEAL LIP
8
9
10
12
7
10
12
14
11
19
16
BLADE & SPINDLE ASSEMBLY: RD6000 (SN--793924 AND
AFTER) RD7200 (SN--688691 AND AFTER) & RD8400 (ALL)
CD4987
14
15
13
3
2
1
Ref Part No
No
No Used Description
3 55345 1 Chain shield plate (for RD6000 only) -or-
3 53554 1 Chain shield plate (for RD7200 only) -or-
3 52885 2 Chain shield plate (for RD8400 only)
13 1256 * -- 3/16 x 1 Cotter pin
14 6697 * -- 3/8 NC x 1 Carriage bolt GR5, plated
15 14350 -- 3/8 NC Flanged hex locknut
Ref Part No
No
No Used Description
-- 55348 -- Chain shield assembly (RD6000)
-- 53566 -- Chain shield assembly (RD7200)
-- 52856 -- Chain shield assembly (RD8400)
1 55346 1 Headless pin (for RD6000 only) -or-
1 53556 1 Headless pin (for RD7200 only) -or-
1 52857 2 Headless pin (for RD8400 only)
2 4763 -- 3-Link chain, 1/4 Proof (use 54 for
RD6000; 66 for RD7200;
78 for RD8400)
RD6000, RD7200 & RD8400
REAR CHAIN SHIELDING ASSEMBLY
* Obtain Locally
(Rev. 7/24/01)