SETTING MON - FRI
1. Press set? until SET and PROG? are shown
in the display. Press OK to select PROG to
continue with programming.
2. Press OK to select MON-FRI.
3. Press OK to select ON time.
NOTE: Speed up the display by holding down
the + or - buttons.
4. Press + or - to change the ON time.
5. Press set? to set the ON time and select the
OFF time.
6. Press + or - to change the OFF time.
7. P r e s s set? to set the OFF time and select the
next ON time.
Repeat operations 4 to 7 to set the second and
third ON/OFF times.
NOTE: After pressing set? for the third hot
water pre-heat OFF time the display
shows SET MON ...see next page
DT10RF RECEIVER
PROGRAMMABLE SETTINGS
DT10RF OPTIMISING PROGRAMMER
INSTRUCTION MANUAL
8 716 115 494a (02.2009)
OPERATING & INSTALLATION
INSTRUCTIONS
19
To Next Page
Loading...
