Worcester DT10RF User Manual

OPERATING & INSTALLATION
INSTRUCTIONS
DT10RF OPTIMISING PROGRAMMER
INSTRUCTION MANUAL
8 716 115 494a (02.2009)
28
DIGISTAT
INSTALLATION
DIGISTAT / DT10RF RECEIVER
MOUNTING THE DIGISTAT
Positioning RF room thermostats
The Digistat is a radio frequency device which is
very flexible for positioning as there is no need for
hard wiring to the appliance. The device should be
mounted in a open area, no closer than 30cm from
metal objects, including wall boxes.
Mount the Digistat on a wall which is not subject to
direct sunlight or draughts, preferably on an inside
wall, 1.5 metres above the floor. The Digistat must
also not be directly influenced by radiators or other
appliances giving off heat.
1. Remove the front cover using a flat screwdriver
and separate from back plate.
Mounting the digistat
To cancel signal strength mode:
1. Remove the batteries fron the transmitter to
cancel the constant transmission.
2. After a few seconds the receiver display will
show ‘---’ .
3. Press ‘OK’ on the receiver display and the display
will return to the time with the ‘CH and Antenna’
flashing.
4. Re-insert the batteries into the transmitter and the
RF link will be re-established.
2. Fix the back plate directly onto the wall using
suitable wall plugs and screws.
8_716_115_494a 9/2/09 09:49 Page 30

Worcester DT10RF Specifications

General

Compatibility	Worcester Bosch Boilers
Display	LCD
Programming	7-day programmable
Mounting	Wall-mounted
Wireless	Yes
RF Frequency	868 MHz
Accuracy	±0.5°C
Type	Digital
Power Source	Battery
Communication	Radio Frequency