Worcester DT10RF User Manual

DT10RF OPTIMISING PROGRAMMER
INSTRUCTION MANUAL
8 716 115 494a (02.2009)
OPERATING & INSTALLATION
INSTRUCTIONS
29
DIGISTAT / DT10RF RECEIVER
TO CHECK PREVIOUSLY
INSTALLED UNIT
3. Replace the front cover by locating in position and
pushing fully onto the back cover.
To check signal strength on previously
installed and paired units :
1. Press the ‘set’ button 4 times .
2. Press ‘OK’ once.
3. Press the ‘set’ button 5 times. The display will
show ‘SSI and OFF’.
4. Press the ‘+’ button so that the display shows
‘SSI, Antenna and ON’.
5. Press the ‘set’ button so the display shows ‘SSI
and Antenna’.
6. After a few seconds the display will show ‘---’.
7. R e m o v e t h e b a t t e r i e s f r o m t h e t r a n s m i t t e r a n d w a i t
until the display has faded away
.
8. Press and hold the ‘+’ button on the transmitter
while re-inserting the batteries and keep the
button depressed until the display shows ‘rF’ .
DIGISTAT
INSTALLATION
8_716_115_494a 9/2/09 09:49 Page 31

Worcester DT10RF Specifications

General

Compatibility	Worcester Bosch Boilers
Display	LCD
Programming	7-day programmable
Mounting	Wall-mounted
Wireless	Yes
RF Frequency	868 MHz
Accuracy	±0.5°C
Type	Digital
Power Source	Battery
Communication	Radio Frequency