Settings in the service menu
Greenstar 4000 – 6 720 891 161 (2020/09)
50
7.2 Service menu
7.2.1 Overview of the service menu
Benchmark
–Flow temp.
–DHW flow rate
– Hot water temp.
Info
–Current status
– Current fault
– Fault history
–Boiler
– Max. heat output
–Actual temp.
– Set flow temp.
–HEx temperature
–Act. burner mod.
– Burner output
– Ionisation current
– Pump mod.
–Outside temp.
–Burner starts
– Hours run
–System pressure
–Hot water
–Max. output
–DHW flow rate
– DHW act. temp.
– Hot water temp.
–Inlet temp.
1)
–DHW set temp.
– Autom. filling
2)
–System pressure
– Last refill dur.
– Status
– Refilling active
–System
–Contr.device ver.
–Progr. unit ver.
–SW sub-ver.
–Code plug no.
–Code plug ver.
–Key
3)
–Solar
1)
– Collector temp.
– Cyl.temp.bottom
– Collector pump
–Solar fault
Settings
– Hydraulics
– Low-loss header
– DHW configuration
– HC1 configuration
– Pump config.
–Heating
–Max. heat output
– Standby time
– Anticyc. temp. off
– Anticycle temp. on
–Hot water
– Turbine signal del.
– DHW start del.
– CH delay
–Man. TD line
–TD-Temperature
–Max. TD duration
–Pump
–Pump range map
– Pump ctr. mode
– Min. output
4)
–Max. output
4)
–Pump overrun
–Special function
– Ventilation func.
– 3-WV mid. pos.
– Filling valve avail.
– Autom. filling
– Min. Sys. Pres.
– Target Sys. Pres.
– Max. refill time
– Htg. sys.type
–Reset refilling
– Start filling
–Maintenance
–Maintenance type
– Without (off)
– Burner run time
– Boiler run time
–Service date
3)
– Landlord
3)
–End date
–Maint. reminder
– Installer tel. no.
– Limit values
– Max. flow temp.
– Max. DHW temp.
– Min. boiler outp.
–Heating curve
–Enable
–Htg. curve base
– Htg. curve end
– Summer mode
–Frost prot.
– Frost temp. limit
1) Not available in every system configuration.
2) Menu items only visible if automatic filling facility fitted
3) Only available with installed Key Timer (accessory)
4) Available when Pump range map has been changed to Output dependent
To Next Page
Loading...
Need help?
General