GB IRE
GB
IRE
00800 34 99 67 53
Troubleshooting
Some problems may be caused by minor faults that you can fix yourself. To do so, follow
the instructions in the following table.
If it is still not possible to resolve the problem with the multifunction-tool, contact After
Sales Support.
Problem Possible cause Solution
1.
The handle
6
/
multifunction-
tool cannot be
mounted.
The inside thread
18
is dirty.
− Always keep the inside thread
clean as described in the
chapter
“Cleaning and maintenance”.
The washer
10
, the
Allen head screw
9
,
the Allen wrench
8
or
the multifunction-tool
is bent/damaged.
− Contact the After Sales Support
of the manufacturer and have
the damaged or defective part
replaced.
2.
The extractor
line
17
/dust
extraction
adapter
7
is loose/keeps
falling off.
The extractor line/the
dust extraction adapter
is not properly
mounted.
− Use the holding clips
2
to
secure the extractor line on the
housing of the multifunction-tool.
− Push the dust extraction adapter
firmly onto the connecting
nozzle of the extractor line and
turn it counterclockwise to fix it
in place.
3.
The multi-
function-tool
cannot be
switched on.
The socket has no
power.
− Check the socket by connecting
another device.
The mains plug
5
has not been inserted
properly.
− Check to make sure that the
mains plug is properly seated.
The mains plug has not
been inserted in the
socket.
− Insert the mains plug in a
socket.
The On/Off switch
1
is stuck.
− Keep the On/Off switch clean
as described in the chapter
“Cleaning and maintenance”.
The mains plug/On/Off
switch is defective.
− Contact the After Sales Support
of the manufacturer.
To Next Page
Loading...
