Mounting the parallel guide
1. Hold the eccentric lever
30
up and set the parallel guide
13
on the rail
42
.
14
41
13
30
42
2. Loosen the wing nuts
41
by turning them a few revolutions and push the stop
rail
14
onto the parallel guide so that the metal plate glides into the profile of the
stop rail.
3. Tighten the wing nuts again.
For removal, lift the front of the parallel guide slightly with the eccentric lever
30
and
reach under the stop rail with your other hand.
Mounting⁄adjusting the splitting wedge
WARNING!
Risk of injury!
The saw blade is very sharp – even soft touches may result in injury.
− Wear protective gloves during the following steps.
− If necessary, pull the mains plug out of the socket.
You must check and, if applicable, adjust the splitting wedge every time after chang-
ing the saw blade.
1. Remove the two screws
43
and take the insert
44
out.
Always check the insert in the process: Replace it if it is damaged or if it is no longer
flush with the table.
To Next Page
Loading...
Need help?
General
