HANGZHOU WORLDE DIGITAL PIANO CO.,LTD HANGZHOU WORLDE MUSIC ELECTRONIC CO., LTD
WEBSITE: WWW.WORLDE.COM.CN EMAIL:SALES@WORLDE.COM.CN TEL:86 571 88730848
- 18 -
MIDI note number and velocity values. Let’s leave the other setting to “Gate” so the notes shut off when you lift the pad;
you can try the “Toggle” value later if you’d like the MIDI note to stay “On” until you hit the pad a second time.
5.1.3.1 Select the MIDI note number: Kick
The CC number field is used to set the MIDI note number, which makes sense: there are 128 MIDI Controller numbers and
128 MIDI Note numbers. So click the pull-down menu and set this value to 36 to select the General MIDI Kick drum note
number:
We’ll show you how to set Pad 2 to the Snare drum note number in section 5.1.3.2.
5.1.3.2 Select the MIDI note number: Snare
Setting Pad 2 to trigger the snare is done the same way, only by choosing a different MIDI note number (38 in this case):
So now you’re ready to lay down the groove for your song: You have Pads 1 and 2 set to play the Kick and Snare, and
Pads 7 and 8 set to Stop and Start the song.
5.1.4 Assign a Pad to toggle a MIDI CC # between two values
One popular musical effect these days is to take an audio loop, filter it heavily for certain sections of a song, and switch it
back to the full-open sound later in the song. You can pre-configure one of the Orca PAD48 pads to send those commands
to a filter plug-in that should be readily available in your DAW software.
We’ll use Pad 6 for this example. Select it and then use the pull-down Mode menus to select “Switched” and “Toggle”:
To Next Page
Loading...
