Maintenance
EN
30
Attention: When fitting new blades, make sure you replace ALL the blades.
Always use new screws when fitting blades. This is important to ensure blade retention and balance the blade turning disc.
Failure to use new screws could cause serious injury.
Important: After screwing the blade to the blade disc, make sure the blade is able to spin freely.
KEEP IT CLEAN
Your Landroid Vision should be cleaned regularly. This helps keep it in good conditions, especially removing dirt, debris and the
build-up of grass clippings from daily mowing. Turn Landroid Vision off before cleaning it. For extra safety, remove the battery.
Attention: Make sure the battery pack cover is closed when washing your Landroid Vision.
WARNING! YOUR Landroid Vision can only be washed by using a hose! DO NOT use high pressure wa-
sher on your Landroid Vision. High pressure water can go inside the sealings and damage electronic and
mechanical parts.
5 6
Cleaning the upper body
• Clean with a spray bottle filled with water. Don’t use solvents or polishers.
• Use a brush or a clean cloth to remove built-up dirt.
Cleaning the Bottom
• Flip Landroid Vision upside down.
• Remove debris and grass clippings using a brush to remove.
• Be careful not to touch the blades with your hands. Wear gloves for protection.
• Clean the blade disc, the chassis and the front wheel(s) thoroughly with a soft brush or moist rag.
• Rotate the blade disc to ensure it rotates freely. Remove any obstructions. Remove any lodged debris so that they don’t
cause a crack in the blade disk. Even the tiniest crack effects mowing performance.
• Check the blades spin freely around the fixing screws. Remove any obstructions.
To Next Page
Loading...
