Quick reference
EN
38
SYMPTOM CAUSE SOLUTION
Landroid Vision frequently
collides.
The grass is taller than 15 cm. Trim the grass to below 15 cm.
There is grass around suspended
objects such as a hanging fence or
a slide.
Lay magnetic strips or set up a 5 cm non-grass pathway
around the area.
Landroid Vision operative
system crashes when
charging or on standby.
Software or display fault. Restart Landroid Vision.
Landroid Vision shuts
off when docking in the
charging pile.
Landroid Vision fails to charge due to
over temperature protection and is
powered off.
Place the charging base in a shady area or wait until the
temperature has cooled down.
Poor connection.
Check the LED light on the charging pile. Check the con-
nection between the contact pins located on the charging
pile and the charging strip.
Landroid Vision stops in
the working area.
There is an obstacle in the working
area.
Remove the obstacle from Landroid Vision’s working
area.
The cutting height is set too low for
the length of the grass or the grass is
too dense.
Raise the cutting height and then gradually lower.
Landroid Vision flips over.
There is an inclined obstacle on the
lawn.
Exclude the obstacle from Landroid Vision’s working area.
Landroid Vision fails to
connect to the internet.
Please check your router has the
correct settings.
Make sure your router is 2.4GHz or 5GHz. If your router
has two settings, please enable the 2.4GHz or 5GHz
band.
Make sure your router is set to 802.11 mode and wireless
setting is b/g/n mixed.
Make sure your router has the SSID Broadcast function
enabled when you connect the machine with the App.
You can close it after you connect successfully.
Make sure DHCP function is enabled.
If you changed your Wi-Fi network, you need to connect
Landroid Vision to the new network.
If you have a “Fritz! box” router, please make sure activate
“Allow communication between devices in same network”
in the settings.
Please check whether the router is di-
sconnected or WIFI SSID is changed.
Make sure the router is connected and WIFI SSID is
correct.
The software upgrade
fails.
The Wi-Fi signal is weak. Move closer to the router to strengthen the signal.
The battery level is less than 50%.
Place Landroid Vision on the charging station or ensure
that the battery level is above 50%.
Your Landroid Vision
beeps when you are
adjusting “month / hour /
minute”.
It is normal.
Counter clockwise the to adjust.
Environmental protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check
with your Local Authority or retailer for recycling advice.
Remove the used battery pack from the appliance and dispose of it at the most convenient recycling facility. If in doubt, consult
your local environmental protection department.
To Next Page
Loading...
