Worx WX427 User Manual

14
Compact circular saw WX427
airborne dust. It also keeps dust out of the working
elements of the guard.
7. USING THE LASER
The laser is used as a cutting guide and should form a
red line on the material surface that is exactly aligned
with the blade alignment indicator (23).
Press down the laser on/off switch (21) to turn on the
laser.
Press down the laser on/off switch again to turn off the
laser.
NOTE: Clean the laser generator periodically.
WARNING: Never stare directly into the laser
beam and never point the beam at anybody. The
laser beam energy is extremely harmful to human eyes.
WARNING: When not in use, always turn the
laser off to save the battery capacity.
To replace laser batteries (See Fig. E1-E3)
The saw comes with laser batteries well assembled.
When battery capacity runs out, replace batteries as
follows:
Use 1.5V batteries model LR44, typical to calculators,
cameras and similar small electronics.
Move the battery storage cover in the direction the
arrow (on the cover) points. Then lift the battery storage
cover.
You can see one end of a cord. To remove the batteries,
just slowly pull the end of the cord. The two batteries
will be taken out along with the cord.
To fit new batteries, adjust the position of the cord and
insert two batteries in place. Make sure two batteries
are pressed on the cord. Then restore the cover.
NOTE: Pay attention that “+/-” of the batteries are the
same as the illustration on the machine.
8. RECOMMENDATION THAT THE TOOL ALWAYS
be supplied via a residual current device with a rated
residual current of 30 mA or less.
WorKinG hinTS for your Tool
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance and
cutting quality depend essentially on the condition and
14 13 19 15
22
A1
A2
B
C1
C2
D
E1
E2
E3

Worx WX427 Specifications

General

Product color	Black, Orange, Stainless steel
Protection class	II
Blade bore	9.5 mm
Blade diameter	120 mm
Idle speed (max)	3700 RPM
Sound power level	87 dB
Blade diameter (min)	115 mm
Cutting depth (45º)	30 mm
Cutting depth (90º)	46 mm
Sound pressure level	76 dB
Sound level uncertainty	3 dB
Saw blade included	Yes
Vibration emission	6.82 m/s²
Input power	710 W
Power source	AC

Weight and Dimensions

Weight	2300 g