1312
20V Li-Ion multi-purpose saw EN
12
Cutting
WARNING!
• Never hold the pivot
head when operating the tool.
• Never hold the motor cover
when operating the tool.
Always use a blade suited to the
material and material thickness
to be cut. Before cutting any
type of material, be sure it is
firmly anchored or clamped to
prevent slipping. Holding the
work by hand or against your
body leaves it unstable and may
lead to loss of control.
• Whenever possible, the saw
foot plate must be held firmly
against the material being
cut. This will prevent the saw
from jumping or vibrating and
minimize blade breakage.
See Fig. G1 – G3
LED Work Light See Fig. H
WORKING HINTS FOR YOUR
MULTI-PURPOSED SAW
If your power tool becomes too hot, run no-load
for 2-3 minutes to cool the motor. Avoid prolonged
usage at very low speeds.
Any movement of the material may affect the quality
of the cut. The blade cuts on the upward stroke and
may chip the uppermost surface.
Ensure your uppermost surface is a non-visible
surface when your work is finished.
MAINTENANCE
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
TROUBLESHOOTING
Symptom
Possible
Causes
Possible
Solution
The tool
suddenly
stops during
operation.
Over load
Battery
temperature
too high
Low battery
capacity
Relieve the
load on the
machine
immediately
and allow
cooling for
approx. 30
seconds by
running the
machine on
no-load.
Charge the
battery pack.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
DECLARATION OF
CONFORMITY
We,
POSITEC Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product,
Description WORX Li-ion Multi-Purpose Saw
Type WX550 WX550.1 WX550.4 WX550.9 (5-des
-
ignation of machinery, representative of Saw)
Function Sawing various materials
Complies with the following Directives,
2006/42/EC, 2011/65/EU, 2014/30/EU
Standards conform to
EN 55014-1, EN 55014-2
EN 60745-1, EN 60745-2-11
The person authorized to compile the technical file,
Name Marcel Filz
Address POSITEC Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
2019/02/28
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd.
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
To Next Page
Loading...
Need help?
General
Weight and Dimensions
